Category Archives: Flow Meter Case Studies

Problem: Opening the pipe to measure sample flow rate could expose technicians to toxic levels of ozone. Leaving valves wide open wastes large volumes of water. If the flowrate is to low or too high analyzer readings are not accurate. … Continue reading →

Problem: The time required to maintain the old system using rotameters had become a burden. Crews were required to check and clean glass tubes. In some cases, the tubes could be cleaned but in others the etching was too severe. … Continue reading →

Problem: Portable cleaning solution carts need to be loaded with caustic and acidic cleaning agents. These agents vary in density and pH. Both batch and continuous total are required when loading the carts with solutions. Solution: Choosing the Assured Automation … Continue reading →

Problem: This customer needed an accurate way to measure hot water as it goes into a mash tank. Later, the meter is used to measure chemicals during the cleaning process. The staff needs a meter that is easy to install … Continue reading →

Problem: Stations need a way to monitor propane dispensed by volume and by weight for inventory tracking. The propane dispenser uses volume measurement while portable bottles are sold by weight. The solution to track both amounts requires accuracy, simplicity and … Continue reading →